100-101 : CCNA Interconnecting Cisco Networking Devices 1 (ICND1)
SIMULATION This topology contains 3 routers and 1 switch. Complete the topology. Drag the appropriate device icons to the labeled Device Drag the appropriate connections to the locations labeled Connections. Drag the appropriate IP addresses to the locations labeled IP…
SIMULATION There are three locations in a school district of a large city: ROUTER -M, ROUTER -W and ROUTER -U. The network connection between two of these locations has already functioned. Configure the ROUTER -M router IP addresses on the…
SIMULATION
Two routers named Atlanta and Brevard are connected by their serial interfaces as shown in the exhibit, but there is no data connectivity between them. The Atlanta router is known to have a correct configuration. Given the partial configurations shown…
Refer to the exhibit. After configuring two interfaces on the HQ router, the network administrator notices an error message. What must be done to fix this error? A. The serial interface must be configured first. B. The serial interface must…
Refer to the exhibit. Why was this message received? A. No VTY password has been set. B. No enable password has been set. C. No console password has been set. D. No enable secret password has been set. E. The…
Refer to the exhibit. Serial 0/0 does not respond to a ping request from a host on the FastEthernet 0/0 LAN. How can this problem be corrected? A. Enable the Serial 0/0 interface. B. Correct the IP address for Serial…
Refer to the exhibit. A technician pastes the configurations in the exhibit into the two new routers shown. Otherwise, the routers are configured with their default configurations. A ping from Host1 to Host 2 fails, but the technician is able…
A receiving host has failed to receive all of the segments that it should acknowledge. What can the host do to improve the reliability of this communication session? A. decrease the window size B. use a different source port for…
Refer to the exhibit. A problem with network connectivity has been observed. It is suspected that the cable connected to switch port Fa0/9 on Switch1 is disconnected. What would be an effect of this cable being disconnected? A. Host B…