Which two neighbor types are supported in a BGP environment?
Which two neighbor types are supported in a BGP environment? (Choose two.) A. directly attached B. internal C. external D. autonomous E. remote
Which two neighbor types are supported in a BGP environment? (Choose two.) A. directly attached B. internal C. external D. autonomous E. remote
Scenario An administrator is trying to ping and telnet from Switch to Router with the results shown below: Click the console connected to RouterC and issue the appropriate commands to answer the questions. For this question we only need to…
You are configuring an IP SLA ICMP Echo operation to troubleshoot a network connectivity issue. When do you enter an IP address to test the IP SLA? A. when you define the ICMP Echo operation B. when you enable the…
You have configured a router with an OSPF router ID, but its IP address still reflects the physical interface. Which action can you take to correct the problem in the least disruptive way? A. Reload the OSPF process B. Reboot…
Which two values must you specify to perform an ACL-based Path Trace using APIC-EM? (Choose two.) A. source IP address B. destination port C. destination IP address D. source interface E. source port
Refer to the exhibit. Given this output for SwitchC, what should the network administrator’s next action be? A. Check the trunk encapsulation mode for SwitchC’s fa0/1 port. B. Check the duplex mode for SwitchC’s fa0/1 port. C. Check the duplex…
Which type of access list compares source and destination IP addresses? A. standard B. extended C. reflexive D. IP named
Refer to the exhibit. What is the effect of the given configuration? A. It configures an inactive switch virtual interface. B. It configures an active management interface. C. It configures the native VLAN. D. It configures the default VLAN.
In which STP state does MAC address learning take place on a PortFast-enabled port? A. discarding B. learning C. forwarding D. listening
Which command can you enter to configure a local username with an encrypted password and EXEC mode user privileges? A. Router(config)#username jdone privilege 1 password 7 08314D5D1A48 B. Router(config)#username jdone privilege 1 password 7 PASSWORD1 C. Router(config)#username jdone privilege 15…