The kickstart image is corrupted on a Cisco Nexus 7000 switch. Which procedure is used to download a new kickstart image? A. Boot the system and press Ctrl-] while the memory test is in progress to interrupt the boot loader.…
Which situation results in a flashing blue status LED on a Cisco Nexus 7000 switch I/O module? A. The switch has just been powered on, and the module is resetting. B. The module is resetting and both ejector levers are…
Which two features must be licensed on a Cisco Nexus 7000 Switch? (Choose two.) A. Layer 3 B. Virtual Device Contexts C. Virtual Port Channel D. Fibre Channel
Which two features must be licensed on a Cisco Nexus 5548UP Switch? (Choose two.) A. Virtual Port Channel B. Fibre Channel C. FabricPath D. iSCSI
Which field in an Ethernet 11 frame performs the same function as the DSAP field in an 802.3 Ethernet frame? A. Start of frame B. EtherType C. Frame check sequence D. Subnetwork Access Protocol E. Logical Link Control
Which command can change the sequence of a router boot process? A. config-register B. configuration-register C. conf-register D. config-registration
A network engineer notices that the MAC address table on a network switch is full. What type of Layer 2 network behavior will occur while the network MAC address table remains full? A. All frames generated within the Layer 2…
Which two features must be licensed on a Cisco Nexus 5548UP Switch? (Choose two.) A. Virtual Port Channel B. Fibre Channel C. FabricPath D. iSCSI
Ethernet 1/1 is assigned IP address 10.1.1.1 with subnet mask 255.255.255.0. Which configuration is used to configure EIGRP on a Cisco Nexus 7000 switch? A. Option A B. Option B C. Option C D. Option D
VLAN 10 is assigned IP address 10.1.1.1 with subnet mask 255.255.255.0. Which configuration is used to route the IP subnet but not form OSPF neighbors on a Cisco Nexus 7000 switch? A. B. C. D.