Refer to the exhibit. A customer has connected ports from a Cisco UCS 6296 using factory default settings, in this way: -Ports 45-48 connected to an upstream Cisco MDS switch -Ports 16-19 connected to an upstream Cisco Nexus 5596 switch…
Which two options are two functions of the data center access layer? (Choose two.) A. high data transfer rate B. packet filtering C. server connections D. QoS policy enforcement E. high network fault tolerance F. VLAN creation
Which requirement is unique to service profile templates? A. VLAN B. VSAN C. pooled Identities D. vNIC E. vHBA
What native Fibre Channel technology facilitates connecting multiple Fibre Channel devices behind a single FC address? A. N-Port Virtualization B. N-Port Identification Virtualization C. Fibre Channel Arbitrary Loop D. Fiber Channel over Ethernet
What data center networking technology is used to converge storage and IP networks within a data center? A. ATA B. FCIP C. iSCSI D. FCoE
A network design engineer is asked to design a SAN for a company. Which three underlying principles of SAN design should be considered? (Choose three.) A. scalability of LAN infrastructure; reduced Ethernet QoS complexity B. port density and topology requirements;…
A SAN administrator recently added a new zone to the VSAN 2 zoneset named zoneset2, but the server is still unable to access the shared storage. What configuration will resolve this Issue? A. zoneset activate zoneset2 B. copy running-config startup-config…
What link aggregation technology could be used when configuring port-channels for connecting an access switch to vPC Domain? A. Dot1q B. LACP mode on C. Port Aggregation Protocol (PAgP) D. LACP mode active E. Nonegotiate mode
What is the benefit of virtual contexts in ACE for server load balancing? A. acts as several virtual appliances within a physical appliance B. compresses the data communication on ACE platforms C. integrates ACE gear with ASA firewalls for extra…
An engineer is configuring a server for storage connectivity using a Cisco MDS switch. The engineer connects the server to the switch, powers up the server, and then wants to verify that the server has logged into the fabric. Which…