Which statement describes the no bgp default route-target filter command? A. Prefixes that are received with route targets and distinguisher are accepted. B. Prefixes that are received with route targets and distinguisher are not accepted. C. Prefixes that are received…

Which two statements about MPLS L3 VPN RDs are true? (Choose two.) A. They enable EIGRP to use address families to separate traffic between IPv4 and VPNv4. B. They are represented as 32-bit values C. They are represented as 64-bit…

Which is the primary function of a MPLS L3 VPN route target? A. It imports and exports identified routes into selected VRFs. B. It uniquely identifies NLRIs that have the same numeric value. C. It imports the external routes it…

Refer to the exhibit. Which statement describes the result of this configuration? A. R1 redistributes BGP routes into the OSPF process of VRF custabc as E1 routes. B. R1 redistributes BGP routes into the OSPF process of VRF custabc as…

You are writing the requirements for an MPLS L3VPN environment that uses MP-BGP between PE routers. In this environment, route targets and route distinguishers need to be advertised between the PE routers. Which three operations meet these requirements? (Choose three.)…

Refer to the exhibit. The CE router has established a BGP peering with the PE router, and the CE will use the core infrastructure of the PE as a backbone carrier to support CSC. Which additional task can you perform…

Refer to the exhibit. Which statement about this configuration is true? A. Router 1 will accept multicast routes with a route-target of 12:1. B. 192.168.1.2 must be reachable by all routers participating in the mvpn-intranet MVRF. C. Router 1 has…

Which kind of traffic is supported in an MVPN Extranet? A. PIM dense mode with Reverse Path Forwarding B. PIM dense mode C. PIM sparse mode D. Bidirectional PIM

While implementing Layer 3 MPLS VPN, which feature should an engineer use at the PEs to transform the customer IPv4 prefixes into a unique 96-bit prefix? A. RT B. VC ID C. RD D. PW ID

With Layer 3 MPLS VPN implementations on Cisco IOS XR PE routers, an interface is assigned to a VRF using the vrf command in which configuration mode? A. RP/0/RP0/CPU0:PE(config-bgp)# B. RP/0/RP0/CPU0:PE(config-if)# C. RP/0/RP0/CPU0:PE(config-bgp-af)# D. RP/0/RP0/CPU0:PE(config-vrf)#