Refer to the exhibit. What would be the correct configuration for the ports labeled? A. vlan 35fcoe vsan 35int eth1/31channel-group 15 mode activeint eth 1/32channel-group 15 mode activeint portchannel15switchport mode trunkswitchport trunk allowed vlan 35spanning-tree port type edge trunkint vfc15bind…
Under what circumstance can a Cisco Nexus 5548 perform an ISSU (nondisruptive)? A. When configured for VPCs B. When configured for L3 C. When an STP-enabled switch is connected downstream D. When the STP Bridge Assurance feature is running on…
When using Virtual Port Channel (vPC) on a Nexus 5500 switch, what protocol is responsible for synchronization of configuration, spanning tree, MAC and VLAN information? A. Fibre Channel over Ethernet (FCoE) B. Spanning Tree Protocol (STP) C. LACP D. Cisco…
Which hardware device should provide Fibre Channel services in a FlexPod design? A. Cisco UCS 6248 Fabric Interconnect B. NetApp FAS C. Cisco Nexus 3000 D. Cisco Nexus 5500
Refer to the exhibit. Following FlexPod recommended practices, which portchannel configuration is valid for the connectivity shown? A. A and B. portchannel 1C and E. po2 and vpc 2D and F. po3 and vpc 3G and H. portchannel 1I and…
In a FlexPod design, when can NetApp storage be directly connected to a Cisco UCS server? A. Never B. Always C. Only in a FlexPod Select design D. Only in a FlexPod Express design E. Only in a FlexPod DataCenter…
Which Cisco Nexus switch is designed for low latency L2/L3 IP only networks? A. Nexus 5548 B. Nexus 7000 C. Nexus 3048 D. Nexus 5596
Cisco UCS Manager may be used to manage which four tasks within a Cisco UCS domain? (Choose four) A. Cisco UCS hardware including the chassis, servers, fabric interconnects, and i/o modules B. Cisco UCS resource management including WWN addresses, MAC…
Which item is an example of Role-Based Access Control and multi-tenancy support that can be applied to a UCS environment using the Cisco UCS Manager? A. Create roles for Data ONTAP Vserver administrators B. Create a storage administrator role with…
For FI 6248 with a GEM module, what is the possible assignment of ports for native Fibre Channel and Ethernet? A. Eth ports: 1-21, 33-48, Fibre Channel ports. 22-32 B. Eth ports: 1-18, 33-40, Fibre Channel ports. 19-32, 41-48 C.…