Refer to the exhibit. A NOC engineer needs to tune some postlogin parameters on an SSL VPN tunnel. From the information shown, where should the engineer navigate to, in order to find all the postlogin session parameters? A. “engineering” Group…
Which three action ranges are in the NG IPS profile? (Choose three.) A. block only B. block and monitor C. block and do not monitor D. allow only E. allow and monitor F. allow and do not monitor
Refer to the exhibit. Which command enables the stateful failover option? A. failover link MYFAILOVER GigabitEthernet0/2 B. failover lan interface MYFAILOVER GigabitEthernet0/2 C. failover interface ip MYFAILOVER 172.16.5.1 255.255.255.0 standby 172.16.5.10 D. preempt E. failover group 1 F. primary G.…
When the Cisco ASA appliance is processing packets, which action is performed first? A. Check if the packet is permitted or denied by the inbound interface ACL. B. Check if the packet is permitted or denied by the outbound interface…
An inside client on the 10.0.0.0/8 network connects to an outside server on the 172.16.0.0/16 network using TCP and the server port of 2001. The inside client negotiates a client port in the range between UDP ports 5000 to 5500.…
On Cisco ASA Software Version 8.3 and later, which two statements correctly describe the NAT table or NAT operations? (Choose two.) A. The NAT table has four sections. B. Manual NAT configurations are found in the first (top) and/or the…
Refer to the exhibit. Which traffic is permitted on the inside interface without any interface ACLs configured? A. any IP traffic input to the inside interface B. any IP traffic input to the inside interface destined to any lower security…
On the Cisco ASA, tcp-map can be applied to a traffic class using which MPF CLI configuration command? A. inspect B. sysopt connection C. tcp-options D. parameters E. set connection advanced-options
Refer to the exhibit. Which Cisco ASA CLI commands configure these static routes in the Cisco ASA routing table? A. route dmz 10.2.2.0 0.0.0.255 172.16.1.10 route dmz 10.3.3.0 0.0.0.255 172.16.1.11 B. route dmz 10.2.2.0 0.0.0.255 172.16.1.10 1 route dmz 10.3.3.0…
Which four unicast or multicast routing protocols are supported by the Cisco ASA appliance? (Choose four.) A. RIP (v1 and v2) B. OSPF C. IS-IS D. BGP E. EIGRP F. Bidirectional PIM G. MOSPF H. PIM dense mode