Which two issues can cause a Cisco Unified Communications Manager to fail to register with its Cisco SAF Forwarder? (Choose two.) A. Incorrect user credentials were used on the SAF Forwarder. B. CCD requesting service was not activated. C. CCD…
As administrator replaced a faulty IP phone with a new one by replacing the hardware and editing the phone MAC address in the device configuration in Cisco Unified Communications Manager. When the administrator tries to the save the configuration, the…
Refer to the exhibit. The BR phones can only support G.711 codec. When a call is placed from a BR phone to an HQ phone, the call fails. The message “not enough bandwidth” is displayed at the BR phone. Which…
Refer to the exhibit. HQ_MRGL is assigned to the HQ IP phones. BR_MRGL is assigned to the BR IP phones. The remote site BR IP phones only support G.711 codec. When a call is placed from an HQ phone to…
Refer to the exhibit. When the user tried to do no shut on the dspfarm profile, the command was accepted but the dspfarm was still in a shutdown state. Which statement indicates the correct resolution or reason for the issue?…
Refer to the exhibit. When a Cisco IP Communicator phone roams from San Jose (SJ) to RTP, the Cisco IP Communicator physical location changes to RTP, and the device mobility group remains the same. All route patterns are assigned a…
The CLI command utils dbreplication reset all was run on a Cisco Unified Communications Manager. However, replication failed to restart. Which course of action should be taken to resolve this issue? A. Restart the replication from the Cisco Unified Communications…
Refer to the exhibit. When an outgoing PSTN call is made through the MGCP gateway shown in the exhibit, which two statements about the called numbers and calling numbers is true? (Choose two.) A. The called number will be subject…
Refer to the exhibit. Click the Voice gateway for the BR2 location to view the output from the debbug voice ccapi inout command and click on 10.1.5.10 to view and search the trace file output. Output can be searched by…
Click the matching criteria for inbound POTS calls on the left and drag them to the order of selection on the right. Select and Place: