Which is a function of RTP?
Which is a function of RTP? A. call multiplexing B. encryption C. payload identification D. replay protection
Which is a function of RTP? A. call multiplexing B. encryption C. payload identification D. replay protection
Which option is used within a dial plan to define the destination that a user is allowed to call? A. dial peers B. calling peers C. calling privileges D. destination patterns
The two main commands that are required for low latency are priority and bandwidth. What is the 114 Cisco 642-437 Exam function of the bandwidth command? A. Identifies a class as strict priority bandwidth. B. Applies to a priority queue.…
Which two options are Cisco recommendations for enabling Cisco Unified Border Element to perform aCAC? (Choose two.) A. a voice service VoIP that is configured on the unique Cisco Unified Border Element to enable the CACservice B. two Cisco Unified…
You are configuring a Cisco Unified Border Element. What do you need to do to achieve address hiding? A. Under the voice service configuration mode, issue the media flow-around command. B. Under the dial-peer configuration mode, issue the codec flow-through…
For multisite deployments with distributed call processing, which three dial plan solutions does Ciscorecommend? (Choose three.) A. using access and site codes B. implementing PSTN access C. defining remote site redundancy options D. defining Call Admission Control for Cisco Extension…
Dial peers and gateways are important in the call routing process. The call routing process is done basedon the inbound dial-peer and outbound dial-peer matching process. Which two statements are true?(Choose two.) A. Dial peer 0 for inbound POTS peers…
112 Cisco 642-437 Exam During the boot process, which server does a Cisco IP phone receive its IP address information from? A. TFTP server B. NTP server C. Cisco Unified Communications Manager Express router D. DHCP server
Using Cisco best practices, on which application should you implement calling privileges? A. quality of service B. type of service C. route pattern D. class of restriction
Which two digit manipulation commands should you use in a POTS dial peer? (Choose two.) A. num-exp B. [no] digit-strip C. translation-profile D. voice translation-profile E. forward-digits