As a voice implementation engineer, you have been asked to deploy Cisco Unified Presence. Cisco Unified Presence needs to communicate with Cisco Unified Communications Manager for user data synchronization. What must you configure to make sure that Cisco Unified Presence…
Which protocol is used for handling communication between Cisco Unified Presence and Cisco Unified Communications Manager? A. Internet Relay Chat B. Session Initiation Protocol for Instant Messaging and Presence Leveraging Extensions C. Session Initiation Protocol D. Internet Message Access Protocol…
You are configuring a secure connection between the Lightweight Directory Access Protocol directory and the Cisco Unified Communications Manager. To complete this configuration, you upload the Lightweight Directory Access Protocol server certificate to the Certificate Management interface. Which two additional…
You are configuring the Cisco Unified Communications Manager server to provision users from a Lightweight Directory Access Protocol directory. Toachieve this goal, you install the Lightweight Directory Access Protocol server. Which additional step is needed to ensure you can provision…
You have configured a Cisco Unity Express server that uses the G.711 codec. You want to send outbound messages in a format that uses lowerband width. However, you want to keep the quality of the incoming message high. Which two…
Which three procedures are necessary to set up Cisco Unity Connection 8.x to use VPIM Networking? (Choose three.) A. Verify network and SMTP connectivity with the remote voice messaging system. B. Create VPIM regions. C. Create VPIM locations. D. Verify…
What are two tasks of a voice connector when processing outgoing messages? (Choose two.) A. Convert the message from MAPI to MIME format. B. Convert the message from MIME to MAPI format. C. Format the To address by using the…
What is the proper format of a custom auto-attendant prompt? A. G.711 u-law, 8 kHZ, 8-bit, mono B. G.711 a-law, 8 kHz, 16-bit, mono C. G.711 a-law, 16 kHZ, 8-bit, stereo D. G.729, 8 kHZ, 8-bit, mono
A user has reported that keys that are pressed when accessing Cisco Unity Express are not being acknowledged by the system. This configuration isfound on the voice-enabled IOS router: dial-peer voice 6800 voip destination-pattern 5… session protocol sipv2 session target…
This configuration is found on the Cisco Unified Communications Manager Express router: interface GigabitEthernet0/1 description Voice Network ip address 172.31.12.1 255.255.255.0 interface Service-Engine1/0 description NM-CUE ip unnumbered GigabitEthernet0/1 service-module ip address 172.31.12.254 255.255.255.0 service-module ip default-gateway 172.31.12.1 ip route 0.0.0.0…