Refer to the exhibit. A company requires a multi-point bridge solution with Cisco 1400 series bridges. The central bridge (B1) is set to 10 dBm, the manufacturing remote bridge (B2) is set to 20 dBm, the inventory remote bridge (B3)…
Refer to the exhibit. Which type of cable connector is displayed that is used to connect antennas to transmitters? A. RP-TNC B. N C. SMA D. SMB E. MMCX
What document must be kept current when a customer is conducting network maintenance? A. installation report B. survey report C. readiness report D. technical report
What three pieces of information should be included in an installation report? (Choose three.) A. software versions of each AP B. configuration files for each WLC C. switch connection for each MAP D. license file for each RAP E. radio…
What measurement can Iperf be used to verify? A. throughput B. RSSI C. SNR D. interference detection E. utilization
An engineer is conducting a failover test with a Mesh deployment by disconnecting the network interface of a RAP. A MAP becomes stranded even though it has an acceptable RSSI value on the link to its neighbor. What are two…
Refer to the exhibit. During a post Mesh deployment survey, an engineer notices frame collisions occurring when MAP-1 and MAP-3 talk to RAP-2. Which type of issue is the engineer observing? A. hidden node B. exposed node C. co-channel interference…
What are two advantages of conducting an active survey versus a passive survey when verifying RF coverage? (Choose two.) A. verifies roaming B. verifies signal level C. verifies packet loss D. verifies SNR E. verifies interferers
What is the minimum CCX version necessary on a client when adding data points during WCS Calibration? A. CCXv1 B. CCXv2 C. CCXv3 D. CCXv4 E. CCXv5
An engineer would like to calibrate the RF environment to improve accuracy. What wireless attribute is added to the floor-level calculation by calibrating the floor? A. TX power B. multipath C. SNR D. attenuation