Drag and Drop
Drag and drop the extended traceroute options from the left onto the troubleshooting they perform on the right.
Select and Place:
Drag and Drop
Drag and drop the extended traceroute options from the left onto the troubleshooting they perform on the right.
Select and Place:
only “correct answer is” has correct answer on this page… not even vceguide
here is the extended traceroute output for those which never saw it:
R4#traceroute
Protocol [ip]:
Target IP address: 10.1.4.6
Source address: 10.1.4.5 troubleshhots connections generated from a specific interface
Numeric display [n]:
Timeout in seconds [3]:
Probe count [3]: 20 limits the number of traceroute packets…
Minimum Time to Live [1]:
Maximum Time to Live [30]: ttl/limits the number of hops…
Port Number [33434]: 25 troubleshoot TCP/UDP states
Loose, Strict, Record, Timestamp, Verbose[none]:
Type escape sequence to abort.
Tracing the route to 10.1.4.6
1 10.1.4.6 32 msec 8 msec 8 msec 4 msec 12 msec 8 msec 12 msec 4 msec 12 msec 8 msec 12 msec 8 msec 4 msec 12 msec 4 msec 12 msec 12 msec 8 msec 12 msec 8 msec
max ttl = limits the number of hops…
probe count = limits the number of traceroute packets…
source address = troubleshoot connecton generated from specific if…
type of service = QoS
port number = troubleshoot TCP/UDP states
Really?? it’s wrong¡¡¡
Port number = troubleshoot tcp and udp port states
type of service = troubleshoots connections generated from a specific interface
type of service = troubleshoots QoS issues
probe count = troubleshhots connections generated from a specific interface
Sorry, wrong.
probe count = limits the number of hops a packet travels
source address = troubleshoots connections generated from a specific interface