What is the maximum number of 1078 MB thin devices that can be bound to the pool shown?
Refer to the exhibit. What is the maximum number of 1078 MB thin devices that can be bound to the pool shown? A. 3 B. 6 C. 200 D. 256
Refer to the exhibit. What is the maximum number of 1078 MB thin devices that can be bound to the pool shown? A. 3 B. 6 C. 200 D. 256
Refer to the exhibit. A data center purchased one new VMAX storage array with Enginuity 5875. After installing the necessary licenses, the admin issued a command to view the information shown in the exhibit. Which command did the admin issue?…
Refer to the exhibit. The SAN zones (Zones 3 and 4) shown in the exhibit have been created during an Open Replicator implementation. The control devices in the Symmetrix array are mapped to both front-end ports. Which Open Replicator operations…
Refer to the exhibit. A Symmetrix is configured with the two RDF Groups RDFG 1 and RDFG 2 as shown in the exhibit. The SRDF R1 devices used by Application 1 (App 1) and Application 2 (App 2) are in…
Refer to the Exhibit. Server A and Server B are running two different applications on SRDF R1 devices on the source Symmetrix. All R1 devices belong to the same RDF group. Both applications are replicated with SRDF/S. Server B has…
Refer to the Exhibit. What is the correct state for the Standard and R1-BCV prior to issuing a symreplicate start command? A. Synchronized B. Split C. Suspended D. Write Enabled
Which status shows that a Virtual LUN migration is complete? A. Migrated B. Synchronized C. Established D. Copied
A Symmetrix VMAX customer wants the ability to perform at least four concurrent FAST swaps. What is the minimum required DRV configuration? A. 4 DRVs equal to or larger than the largest device size B. 4 DRVs for every device…
Which command should be used to change the SRDF operation mode into sync? A. symrdf -g set mode sync B. symrdf -g set sync C. symdg -g set mode sync D. symrdf -g resume
A customer configured FAST VP so data movement can take place from 00:00 to 24:00, but it seems the hot spots have not moved at all. What could be causing this? A. FAST VP is not enabled B. FAST VP…