Home » HP » HP2-Z12 » How do you install an Enhanced Service Module (ESM) on an HP A-MSR30 Series router?
How do you install an Enhanced Service Module (ESM) on an HP A-MSR30 Series router?
A. Remove the router’s Multi-Service Card A (MSCA) and install the ESM on that card.
B. Install the ESM in two side-by-side Smart Interface Card (SIC) slots.
C. Install the ESM in two Multi-Function Interface Module (MIM) slots that are one on top of the other.
D. Open the router chassis and install the ESM on the main board
Correct Answer: D
Explanation/Reference:
To install VPM, VCPMs, and ESMs on an A-MSR 30 Series router, you must open the router’s chassis. Follow these steps:
1. Power off the router and remove the power cord.
2. Remove all cables from the back panel except the grounding cable.
3. Make sure that the router is on a level surface and face the router’s rear panel towards you. Loose the captive screws on the back panel.
4. Raise the chassis cover until the front edge is lifted completely from the chassis bottom.
5. Pull the chassis cover towards you until the tab on the back edge has disengaged from the front panel. Put the cover away.
|
Download Printable PDF. VALID exam to help you PASS.
|
 |
