HP0-Y43 Exam and Free Practice Test - VCEguide
Skip to content
  • Support
  • About
Share The Experience - Real Exam Questions

microsoft-exams

  • Cisco
  • Microsoft
  • CompTIA
  • VMware
  • Oracle
  • Amazon
  • Juniper
  • Checkpoint
  • Exin
  • HP
  • IBM
  • Citrix
  • –View ALL–

Questions

  • Question 1
  • Question 2
  • Question 3
  • Question 4
  • Question 5
  • Question 6
  • Question 7
  • Question 8
  • Question 9
  • Question 10
  • Question 11
  • Question 12
  • Question 13
  • Question 14
  • Question 15
  • Question 16
  • Question 17
  • Question 18
  • Question 19
  • Question 20
  • Question 21
  • Question 22
  • Question 23
  • Question 24
  • Question 25
  • Question 26
  • Question 27
  • Question 28
  • Question 29
  • Question 30
  • Question 31
  • Question 32
  • Question 33
  • Question 34
  • Question 35
  • Question 36
  • Question 37
  • Question 38
  • Question 39
  • Question 40
  • Question 41
  • Question 42
  • Question 43
  • Question 44
  • Question 45
  • Question 46
  • Question 47
  • Question 48
  • Question 49
  • Question 50
  • Question 51
  • Question 52
  • Question 53
  • Question 54
  • Question 55
  • Question 56
  • Question 57
  • Question 58
  • Question 59
  • Question 60
  • Question 61
  • Question 62
  • Question 63
  • Question 64
  • Question 65
  • Question 66
  • Question 67
  • Question 68
  • Question 69

HP0-Y43

Which VLAN types require the command local-proxy-arp enable for all the stations in the VLAN to be able to communicate to each other at Layer 3?

05/20/2017 – by Mod_GuideK 0

In A-Series switches, which VLAN types require the command local-proxy-arp enable for all the stations in the VLAN to be able to communicate to each other at Layer 3? (Select two.) A. Port-based VLAN B. SuperVLAN C. Protocol-based VLAN D.…

When will both PIM and IGMP need to be configured?

05/20/2017 – by Mod_GuideK 0

You are designing a network for a customer, and one of the requirements is to support multicast traffic. When defining configuration steps for the HP E5400 zl switches, when will both PIM and IGMP need to be configured? A. when…

Which type of ACL can be used to meet this need?

05/20/2017 – by Mod_GuideK 0

An administrator needs to create an ACL to block traffic from 192.168.10.23 to all destinations. Which type of ACL can be used to meet this need? A. a standard ACL applied as Routed ACL (RACL) B. an extended ACL applied…

Which statement is true about the HP E5400 zl switch Connection-rate Filtering feature?

05/20/2017 – by Mod_GuideK 0

Which statement is true about the HP E5400 zl switch Connection-rate Filtering feature? A. Any outbound traffic destined for a host that has been throttled or blocked is permitted. B. When enabled, it is automatically globally activated. C. It uses…

What can she do to keep the device from connecting to the network?

05/20/2017 – by Mod_GuideK 0

An administrator of a network of A5800s has found evidence that an unauthorized device is gaining access to the network. All the administrator knows about the device is its MAC address. Assuming that the action she takes does not require…

What is meant by the Address Status column?

05/20/2017 – by Mod_GuideK 0

While onsite configuring an HP E5400 zl switch, you enter ipv6 enable in VLAN 1 configuration context. You type the command show ipv6 at the switch CLI, and receive the result shown in the exhibit. What is meant by the…

What is the remaining step you must take in this process?

05/20/2017 – by Mod_GuideK 0

You are configuring IP multicast on a customer network that has all HP E5400 zl switches installed. All VLANs have been created, and IP addresses and OSPF have been assigned to all routed interfaces. IGMP has been enabled for all…

Where does a Comware switch direct sFlow samples?

05/20/2017 – by Mod_GuideK 0

A network administrator wants to configure a Comware switch to send HP Intelligent Management Center (IMC) sFlow samples. Where does a Comware switch direct sFlow samples? A. To the multicast address defined for sFlow collector B. To the IP address…

When SNMP is enabled on these switches, which version of SNMP is implemented by default?

05/20/2017 – by Mod_GuideK 0

A network administrator is deploying HP 5800 switches at the access layer and wants to manage them with HP Intelligent Management Center (IMC). When SNMP is enabled on these switches, which version of SNMP is implemented by default? A. SNMP…

Which security protocol requires the servers to use digital certificates?

05/20/2017 – by Mod_GuideK 0

Which security protocol requires the servers to use digital certificates? A. AH and ESP for HTTP traffic B. Telnet for console sessions C. SSL and TLS for HTTP traffic D. SSH for console sessions

Posts navigation

1 2 … 7 Next

PDF to VCEplus

Top Popular Questions

Download PDF files for FREE

©2022 VCEguide Team.
Email Support: [email protected]
VCEguide gives free questions, answers and explanations for such certifications as CCNA, CCNP, Azure, A+, Network+, Security+, IBM, VMware...Learn and Pass IT Certification Exams Easily. We does not offer real Microsoft - CompTIA - Amazon - Cisco - Oracle Exam Questions. CFA Institute does not endorse, promote or warrant the accuracy or quality of VCEguide. CFA® and Chartered Financial Analyst® are registered trademarks owned by CFA Institute.
VCEguide does not offer exam dumps or questions from actual exams. We offer learning material and practice tests created by subject matter experts to assist and help learners prepare for those exams. All certification brands used on the website are owned by the respective brand owners. VCEguide does not own or claim any ownership on any of the brands.