In a direct FC connect MSL2024 tape library, the devices are present in the OCP but cannot be seen by the host. What is the most probable cause? A. The HBA had already assigned disk storage B. the devices have…

What must be done before you connect the cables to direct SCSI attached MSL2024 or MSL4048 Libraries? A. connect the terminator to the library B. Disable the device in the windows device manager C. Do a rescan of the SCSI…

Where do you find the letest information about supported HBAs. A. EBS compatibility matrix B. HBAs Vendors web pages C. Hetrogenious SAN design guide D. Support Pages on HP website

When connecting an MSL2024 or 4048 Library with an NSR N1200 to a fiber channel SAN, How are fiber channel LUNs assigned. A. With the LUN management of NSR B. With HP command view MSL Software C. With Hardware Assisted…

Which Tape drive format uses two reel cartridge design A. DLT B. LTO-1 C. LTO-3 D. DDS/DAT

What is the SCSI-ID with the highest priority on a wide SCSI bus? A. 0 B. 7 C. 8 D. 15

SCSI devices are recognized on the SCSI buses of the Fibre Channel interface, but do not appear on the Fibre Channel host. What is the most probable cause? A. too many SCSI devices in the map B. improperly established Fibre…

When do you have to terminate the MSL2024 tape library? A. when using a standard differential or high-voltage differential (HVD) SCSI bus B. to make it compatible with a narrow (50-pin) SCSI bus using high-byte termination C. only when using…

Which statement about the HP StorageWorks MSL2024 and MSL4048 Tape Libraries is correct? A. You can set one SCSI ID for all drives and the robotics controller. B. They support the latest generation LTO tape drives, Ultrium 460, Ultrium 448…

In the exhibit, which component has been removed from the library? Exhibit: A. library controller B. tape drive controller C. diagnostic interface module D. Fibre Channel controller module