You are installing an SFP transceiver in an HP A Series switch’s SFP port. Which steps should you perform? (Select two.) A. Connect the fiber optic cable to the SFP transceiver before installing the transceiver. B. Slide the transceiver into…

Several HP A Series switches are distinguished by a dual-personality (or combo) port. What is an accurate description of this port? A. It can accept either Ethernet Base-T cable or fiber optic cable B. It can accept either Ethernet Base-T…

Which area of the network is considered the backbone? A. data center B. core C. distribution layer D. LAN access layer

Match the name of the HP A-MSR router user interface with the type of access that it controls. Select and Place:

How do you install an Enhanced Service Module (ESM) on an HP A-MSR30 Series router? A. Remove the router’s Multi-Service Card A (MSCA) and install the ESM on that card. B. Install the ESM in two side-by-side Smart Interface Card…

A customer has an HP A7760 AP that operates in standalone (fat) mode. She has purchased several more APs and an access controller. She wants you to convert the current standalone AP to controlled (fit) mode. You have already added…

Which networking products are included in the HP E Series? (Select two.) A. a wireless access point that operates as a managed AP (controlled mode) only B. a wireless access point that operates as a standalone AP (autonomous mode) only…

What information do all HP E Series APs provide through their LEDs? (Select two.) A. whether the AP is performing intrusion prevention B. whether data is being sent or received through the Ethernet port C. whether the AP is receiving…

You are resetting an HP E Series AP to factory defaults using its reset button. How many times should the LEDs blink before you release the button? A. once B. twice C. three times D. four times

Which device requires switch CLI access for initial configuration? A. E-MSM317 Access Device B. E-MSM415 RF Security Sensor C. E-MSM422 Access Point D. E-MSM765 zl Mobility Controller