Which two statements about exception traffic processing are correct? (Choose two.) A. When congestion occurs, only exception traffic is given preference. B. By default, a rate-limiter for exception traffic exists on the internal link between the control plane and the…
Which statement describes the ulst next-hop type that appears in the output of the show route forwarding-table command? A. A list of unicast or multicast forwarding entries waiting to be resolved. B. A list of unicast destination prefixes for which…
Click the Exhibit button. You want to make the OSPF route shown in the exhibit the active route for the 10.10.10.0/24 IP address. Which action is required to accomplish this task? A. Set the static route to no-readvertise. B. Set…
Which layer of the OSI model does a router use to make forwarding decisions? A. Layer 3 B. Layer 4 C. Layer 5 D. Layer 2
What are two functions of the PFE? (Choose two.) A. to maintain the forwarding tables B. to apply the class of service function C. to forward transit traffic D. to monitor the chassis
Click the Exhibit button Referring to the exhibit, which two statements are correct? (Choose two.) A. All other traffic from the Web destined to 172.19.20.50 is accepted. B. All other traffic from the Web destined to 172.19.20.50 is discarded C.…
You are asked to configure a Junos device to perform regular configuration backups Which feature will you configure under the [edit system) hierarchy to accomplish this task? A. archival B. backup-router C. syslog D. tracing
What are two important steps when upgrading an SRX300 Series device? (Choose two.) A. Verify that enough space exists to upload the software package. B. Clear all alarms. C. Reboot the device. D. Verify that the NETCONF protocol is enabled.
Which statement is true about a virtual router routing instance? A. It can be used for Layer 3 VPN implementations. B. It can be used to create a separate routing table. C. An interface in the routing instance can also…
Click the Exhibit button. The next hop identified in the static route command is not directly connected to your router. Referring to the exhibit, what must be added to the command for the static route to work? A. retain B.…