Click the Exhibit button. In the network shown in the exhibit, all switches are configured with the default STP root bridge priority, and Switch A has been selected as root. You recently added the older Switch D into the network…
When working with an MPLS LSP, what will the install 172.16.6.0/24 active command accomplish? A. The command will swap the prefix from inet.0 to inet.3 B. The command will swap the prefix from inet.3 to inet.0 C. The command will…
Click the Exhibit button. Referring to the exhibit, how many milliseconds must pass before the interface ge-0/0/1.0 is considered down? A. 1200 ms B. 900 ms C. 1600 ms D. 2400 ms
Click the Exhibit button. Referring to the exhibit, which statement is correct? A. Routes from 10.1.1.1 are less preferred than the default local preference B. Routes from 10.2.2.2 are less preferred than routes from 10.1.1.1 C. Routes from 10.3.3.3 are…
Click the Exhibit button. Customer-1 wants the Service Provider to allow STP to operate normally on all ports but only allow the MX Series devices to manage the Layer 2 topology. Referring to the exhibit, which feature needs to be…
Click the Exhibit button. You have applied the policy shown in the exhibit to the forwarding table on an MX Series device. How is traffic load-balanced? A. per frame B. per packet C. per segment D. per flow
Click the Exhibit button. Referring to the exhibit, if there is a connection failure between router1 and router2, how much time will pass before the devices declare the BFD session dead? A. 1200 ms B. 300 ms C. 600 ms…
According to Juniper Networks, what are two reasons to peer using loopback addresses when configuring BGP? (Choose two.) A. When establishing an IBGP connection B. When routers are not in the same autonomous system C. When routers are not directly…
Which two statements are true about IBGP on MX Series devices? (Choose two.) A. Neighbors can be located anywhere within the AS B. Interface Lo0 must be used for peering C. It does not support multihop D. It is loop…
You have two MX Series devices connected together and configured for Layer 2 operations. The interface that connects the two routers must carry tagged and untagged traffic. Which approach would meet this objective? A. Configure the interfaces as access ports…