You have committed a configuration on router R1 as shown in the exhibit. However, it resulted in a (*, G) join for only one group (228.1.1.1) on R1. Which additional configuration would result in the creation of a (*, G)…
Referring to the exhibit, which statement is true about the multicast state on R3? A. R3 has no PIM neighbors. B. R3 has no receivers. C. R3 has no route to RP. D. R3 is not receiving any traffic
Which two scenarios would explain the error shown in the exhibit? (Choose two.) A. Packets were dropped in the receive path of the local router. B. The local router received a route withdrawal from the peer. C. Packets were dropped…
You recently added your autonomous system to an existing BGP confederation. You notice that a route that had a local preference of 100 now has a local preference of 50. Which statement explains the change? A. BGP path attributes such…
You are asked to configure an EBGP peering, but the peering does not establish and transitions between the Connect and Active states. Referring to the exhibit, what is causing the problem? A. The number of messages from the BGP peer…
You have been asked to troubleshoot an OSPF problem where the OSPF session will not establish. According to the outputs shown in the exhibit, which statement is true? A. The hold-time interval is set too low. B. There is an…
You have configured an IS-IS adjacency between routers R1 and R2. However, the adjacency is not coming up. Referring to the exhibit, what appears to be the problem? A. The R2 interface is down. B. The ge-1/1/2.0 interface has IS-IS…
One of your router’s OSPF adjacencies is down. What are three reasons for this adjacency state change? (Choose Three) A. A filter has just been configured on one of the OSPF routers. B. The OSPF hello value is the same…
An OSPF neighbor between routers R1 and R2 is stuck in loading state on R2. What are two causes? (Choose two.) A. OSPF is not enabled on the interfaces. B. A firewall filter is blocking OSPF hellos on both sides.…
R1 and R2 are IS-IS Level 1 routers, but are not forming an adjacency. Which two reasons would account for this happening? (Choose two.) A. The remote router is configured for both IPv4 and IPv6. B. The remote router does…