Lab – OSPF
The question mentioned Boston router was not configured correctly or incomplete so we should check this router first. Click on PC-B to access the command line interface (CLI) of Boston router.
Boston>enable (type cisco as its password here)
Boston#show running-config
First, remember that the current OSPF Process ID is 2 because we will need it for later configuration. Next notice that in the second “network” command the network and wildcard mask are 192.168.155.0 and 0.0.0.3 which is equivalent to 192.168.155.0 255.255.255.252 in term of subnet mask. Therefore this subnetwork’s range is from 192.168.155.0 to 192.168.155.3 but the ip address of s0/0 interface of Boston router is192.168.155.5 which don’t belong to this range -> this is the reason why OSPF did not recognize s0 interface of Boston router as a part of area 0.
So we need to find a subnetwork that s0 interface belongs to.
IP address of S0 interface: 192.168.155.5/30
Subnet mask: /30 = 1111 1111.1111 1111.1111 1111.1111 1100
Increment: 4
Network address (which IP address of s0 interface belongs to): 192.168.155.4 (because 4 * 1 = 4 < 5)
Therefore we must use this network instead of 192.168.155.0 network
Boston#configure terminal
Boston(config)#router ospf 2
Boston(config-router)#no network 192.168.155.0 0.0.0.3 area 0
Boston(config-router)#network 192.168.155.4 0.0.0.3 area 0
Boston(config-router)#end
Boston#copy running-config startup-config
Finally, you should issue a ping command from Boston router to Lancaster router to make sure it works well.
Boston#ping 192.168.43.1