The following configuration steps have been completeD.
. WebVPN was enabled on the ASA outside interface.
. SSL VPN client software was loaded to the ASA.
. A DHCP scope was configured and applied to a WebVPN Tunnel Group.
What additional step is required if the client software fails to load when connecting to the ASA SSL page?
A. The SSL client must be loaded to the client by an ASA administrator
B. The SSL client must be downloaded to the client via FTP
C. The SSL VPN client must be enabled on the ASA after loading
D. The SSL client must be enabled on the client machine before loading
agree with johnny
The answer to this should be C.
http://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-generation-firewalls/70511-sslvpnclient-asa.html#step2
From the document above under link “Step 2. Install and Enable the SSL VPN Client on the ASA”. Starting with Step 5, it said to enable the “SSL VPN Client” after uploading the image.
This is very true because I forgot to do this one time after loading a new version of Anyconnect and the client failed to load.