What could be an issue?

Hotspot Question – RIPv2 Troubleshooting

– Router R1 connects the main office to internet, and routers R2 and R3 are internal routers
– NAT is enabled on Router R1
– The routing protocol that is enabled between R1, R2 and R3 is RIPv2
– R1 sends default route into RIPv2 for internal routers to forward internet traffic to R1
– Server1 and Server 2 are placed in VLAN 100 and 200 respectively, and are still running on stick Configuration with router R2.
You have console access on R1, R2, R3 and L2SW1 devices.
Use only show commands to troubleshoot the issues.
Examine R2 configuration,the traffic that is destined to R3 LAN network sourced from Router R2 is forwarded to R1 instead R3. What could be an issue?

A. RIPv2 enabled on R3, but R3 LAN network that is not advertised into RIPv2 domain.
B. RIPv2 routing updates are suppressed between R2 and R3 using passive interface feature.
C. RIPv2 not enabled on R3.
D. No issue that is identified; this behavior is normal since default route propagated into RIPv2 domain by Router R1.

Pass Cisco CCNA 200-301 Exam in First Attempt FULL Printable PDF and Software. VALID exam to help you pass.