What could be the cause of the problem?

Refer to the exhibit.

100-101-ccna-interconnecting-cisco-networking-devices-1-icnd1_img_249
A technician pastes the configurations in the exhibit into the two new routers shown. Otherwise, the routers are configured with their default configurations.
A ping from Host1 to Host 2 fails, but the technician is able to ping the S0/0 interface of R2 from Host 1. The configurations of the hosts have been verified as correct. What could be the cause of the problem?
A. The serial cable on R1 needs to be replaced.
B. The interfaces on R2 are not configured properly
C. R1 has no route to the 192.168.1.128 network.
D. The IP addressing scheme has overlapping subnetworks.
E. The ip subnet-zero command must be configured on both routers.

Pass Cisco CCNA 200-301 Exam in First Attempt

FULL Printable PDF and Software. VALID exam to help you pass.

cisco-exams

Leave a Reply

Your email address will not be published.