Home » Cisco » 200-101 » What does the frame-relay interface-dlci command configure?
What does the frame-relay interface-dlci command configure?
A. local DLCI on the subinterface
B. remote DLCI on the main interface
C. remote DCLI on the subinterface
D. local DLCI on the main interface
Correct Answer: A
Explanation/Reference:
Explanation:
Frame Relay for ICND Exam
http://www.ciscopress.com/articles/article.asp?p=100603&seqNum=3
To assign a data-link connection identifier (DLCI) to a specified Frame Relay subinterface on the router or access server, or to assign a specific permanent virtual circuit (PVC) to a DLCI, or to apply a virtual template configuration for a PPP session, use the frame-relay interface-dlci interface configuration command
Example 4-23 Example of frame-relay interface-dlci Command and the Output of show frame- relay map
R4(config)#interface s1/2.403 point-to-point
R4(config-subif)#frame-relay interface-dlci ?
cisco Use CISCO Encapsulation
ietf Use RFC1490/RFC2427 Encapsulation
ppp Use RFC1973 Encapsulation to support PPP over FR protocol Optional protocol information for remote end
R4#show frame-relay map
Serial1/2.403 (up): point-to-point dlci, dlci 403(0xC9,0x3090), broadcast status defined, active R4#