What is the cause of this problem?

A network administrator is troubleshooting the OSPF configuration of routers R1 and R2. The routers cannot establish an adjacency relationship on their common Ethernet link.

100-105-interconnecting-cisco-networking-devices-part-1_img_139

The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2.
Based on the information in the graphic, what is the cause of this problem?
C. The cost on R1 should be set higher.
B. The priority on R1 should be set higher.
A. The OSPF area is not configured properly.
D. The hello and dead timers are not configured properly.
E. A backup designated router needs to be added to the network.
F. The OSPF process ID numbers must match.

cisco-exams

One thought on “What is the cause of this problem?

Leave a Reply

Your email address will not be published. Required fields are marked *


The reCAPTCHA verification period has expired. Please reload the page.