Home » Cisco » 300-101 » What is the command to enable NAT-PT?

What is the command to enable NAT-PT?

What is the command to enable NAT-PT?
A. ipv6 nat
B. ipv6 nat enable
C. ipv6 nat-pt
D. ipv6 nat-pt enable

One thought on “What is the command to enable NAT-PT?”

RED1 says:

06/10/2018 at 11:00 PM

A is a good response but it should be entered in the interface level:
Example:
conf t
interf fa 0/0
ipv6 nat

Reply