Refer to the exhibit.
A collaboration engineer was asked to attach a Cisco Unified CME to the Cisco UCM network of a client via SAF. The configuration was applied, but the Unified CME was not able to retrieve the dial plan. What must be changed about the configuration to allow the Unified CME to attach to the SAF network pass calls to and from the Unified CM network?
A. Split-horizon must be enabled under EIGRP.
B. The SAF EIGRP instance must be configured under a virtual instance name.
C. The session target on the dial peers should point to the next-hop SAF forwarder.
D. The Cisco Unified CME must be configured for SIP under voice service saf when communicating with Cisco Unified CM clusters over SAF.
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/saf/configuration/xe-3s/saf-xe-3s-book/saf-configuring.html
The following example enters router configuration mode, configures a Cisco SAF Forwarder, enables the service-family forwarder process, and configures an autonomous system named 4533.
Router(config)# router eigrp saf
Router(config-router)# service-family ipv4 autonomous-system 4533