What two commands can you apply on the interfaces?

Your manager asked you to make every port on your switch bypass the normal spanning-tree timers which includes your uplink to other switches.
What two commands can you apply on the interfaces? (Choose two.)
A. spanning-tree portfast
B. spanning-tree portfast default
C. spanning-tree portfast access
D. spanning-tree portfast trunk

cisco-exams

4 thoughts on “What two commands can you apply on the interfaces?

  1. Correct B and D

    B. spanning-tree portfast default : This is in global config mode will enable portfast on all int like the question
    D. spanning-tree portfast trunk : This is on interface config mode, this refer to uplinks on other swtiches(trunks)

  2. No Tom, if the switchport does not have portfast enabled then “B. spanning-tree portfast default” will have no affect.

    Correct answer is A + D.

  3. Your manager asked you to make “every” port…..

    That “every” have not an interpretation….!

    I meen the answer “B+D” is the well…

Leave a Reply

Your email address will not be published. Required fields are marked *


The reCAPTCHA verification period has expired. Please reload the page.