Refer to the exhibit.
While configuring dial plan on a system, an engineer notices the route list in the pictured state.
What will cause this?
A. One subscriber server in CUCM Group is down.
B. Media Resource on the CUCM are oversubscribed.
C. "Run on all active unified CM nodes" is not checked on the route list.
D. "No route group" is added in this Route List.
When I first looked at this I agreed with everyone here that it must be D, but I think this is the usual trick question
I think it has to be A as despite the name we cannot prove that there is more than one subscriber in the group and therefore that is the reason the List cannot register to the SUB.
I do agree with Sal’s point above though.
Whoever came up with this question needs to find a new job!
call manager service cannot run in a publisher server, you are right.
since the run on all active unified cm nodes is unchecked it wont register to the other subs cm servers.
@Sal
I went back and try to configure a new route list. Your explanation also panned out to be correct. Thanks a lot everybody. D wins the vote. The correct answer is D.
Actually the answer is D
I have my lab and I created two RL one without RG and the result of the state is :
Route List Information
Registration: Unknown
IPv4 Address: None
like the picture.
@Anonymous & @Sal are correct.
@ Anonymous
@Sal
The answer is definitely not D. You can not save your config unless Route Group is added
The answer is definitely not C either. I quickly ran this scenario on a production network and leave the box unchecked and registration still happened
@Tony
You are right: you cannot save route list configuration unless Route Group is added but the question says: “While configuring…..”. Before that you add route group, the route list registration status is Unknown.
Then, I again think answer is D
I agree
it says, while configuring dial plan not while configuring a route list. Tony is right!
Correct answer is : D
I agree