When a Layer 2 EtherChannel is configured, which statement about placement of the IP address is true?
A. The IP address is placed on the highest numbered member port.
B. The IP address is placed on the port-channel logical interface.
C. The IP address is placed on the lowest numbered member port.
D. The IP address is assigned via DHCP only.
the no switchport command convert a layer 2 etherchannel into a layer 3 int and the ip config is done over the port channel int.
yes question is not ok. It must say “L3 etherchannel”
there answer B will be ok.
anyway SVI is a router port, conected to a virtual switch (both end are virtual interfaces).
This question is wrong. You can’t put an Ip address to layer 2 Interface. Switch virtual interface is cosidered a layer 3 logical interface.
SVI interface is a Layer 2 logical interface, that is why it is called virtual interface.
Whis is wrong a question. Because no right answer in this list. Answer B is not right. Ip address places on logical interface only on L3 Ether-Channel interface. If you use L2 ether-channel, ip address defines on SVI interface, which binds with VLANs, defined in L2 ether-channel link.
SVI interface is a Layer 2 logical interface, that is why it is called virtual interface.