When is a routing table entry identified as directly connected?
A. when the local router is in use as the network default gateway
B. when the network resides on a remote router that is physically connected to the local router
C. when an interface on the route is configure with an ip address and enabled
D. when the route is statically assigned to reach a specific network
Pass Cisco CCNA 200-301 Exam in First AttemptFULL Printable PDF and Software. VALID exam to help you pass. |
 |
Answer C is correct. Verified.
Answer is C.
B is incomplete. The interface needs an address assigned as well, and in up/up state. Just physically connect it, is not enough.
Directly connected networks are added to the router’s routing table if the interface connected to the network has an IP address configured and is in the up and up state. Connected routes always take precedence over static or dynamically discovered routes because they have the administrative distance value of 0 (the lowest possible value).
I don’t think this is a right answer B would be more fit
Option B is also true ?
If we give a static route specifying an exit interface, It shows as directly connected in routing table.