Multiple users are reporting that they are unable to access the network. The ENTIRE network is shown in the diagram. PCs are not statically assigned IP addresses. The following devices will display settings:
WorkstationA
WorkstationB
WorkstationC
WorkstationD
WorkstationE
WorkstationF
WorkstationG
Laptop1
Laptop2
DHCP server1
DHCP server2
Review the settings and select the box in the diagram that identifies the device causing the issue. Only one device can be selected at a time.
After checking the device that is causing the issue, select the second tab in the lower left hand corner. Identify the reason as to why some users are unable to access the network.
Instructions:
When the simulation is complete, select the Done button to submit.
Part 1
Part 2
Identify the reason as to why some users are unable to access the network.
A. Workstation(s) are plugged into switch ports configured with half duplex.
B. The site-to-site router was configured with the incorrect ACL.
C. DHCP server scope is full and is not providing IP addresses.
D. WAN and LAN ports are reversed on the router.
E. STP had disabled some of the ports on the switch.
F. The NIC driver is not installed.
G. A wireless client is unable to associate to the AP.
Exam N10-008: CompTIA Network+Free dumps for N10-008 in PDF format.High quality N10-008 PDF and software. VALID exam to help you pass. |
 |
Your right to barf at this pathetic question but yes the answer is G because workstation C is the one client who can’t connect because of those reasons you mentioned above
How is the answer G?
If Workstation C has an APIPA address wouldn’t that be a DNS issue?
Are we supposed to choose the device that is causing the issue and then choose from A to G so its a question that requires 2 answers?