Refer to the exhibit. Based on the above commands, when will the output of the show log command be saved?
A. Each time the total CPU utilization goes below 50 percent
B. Each time the total CPU utilization goes above 80 percent
C. Every 5 minutes while the total CPU utilization is above 80 percent
D. Every 5 seconds while the total CPU utilization is above 80 percent
E. Every 5 minutes while the total CPU utilization is below 50 percent
F. Every 5 seconds while the total CPU utilization is below 50 percent
Answer is not available
CPU utilization threshold is set to 80 percent for a rising threshold notification and 50 percent for a falling threshold notification, with a 5-second polling interval
Think the question might be asking for two answers, then AB are both correct
Correct answer should be B – the rising threshold is what kicks it off, and it will monitor every 5 seconds until utilization is below 50% – the falling threshold
This should have answers D, since F is incomplete.
It would only send a falling notification if it was above the rising threshold for 5 sec. That information is unknown. So the only correct answer is D.
URL: https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/bsm/configuration/15-mt/bsm-15-mt-book/bsm-cpu-thresh-notif.html#GUID-646B2201-FA34-4AB9-B313-4DAB45E6361F
Quote:
Setting a Falling CPU Thresholding Notification Example
The following example shows how to set a falling CPU thresholding notification for total CPU utilization. When total CPU utilization, which at one point had risen above 80 percent and triggered a rising threshold notification, falls below 70 percent for a period of 5 seconds or longer, a falling threshold notification is sent.
Router(config)# process cpu threshold type total rising 80 interval 5 falling 70 interval 5