Which action is required to bring the MPLS TE tunnel 0 to up state?

Refer Exhibit

400-201-ccie-sp-written_img_075
A service provider is running MPLS TE across its network. IS-IS is deployed as the IGP for the ISP network. The MPLS TE tunnel 0 configured on PE2 is seen in an operational down state. PE2 is a level-1 router and the destination 192.168.1.1 is located in the IS-IS level-2 area. Which action is required to bring the MPLS TE tunnel 0 to up state?
A. Configure the next-address entries as loose paths in the explicit path.
B. Change the autoroute option from destination to announce.
C. Configure a bandwidth value for the tunnel.
D. Configure an IPv4 address for the Tunnel 0.

cisco-exams

Leave a Reply

Your email address will not be published. Required fields are marked *


The reCAPTCHA verification period has expired. Please reload the page.