Which command enables Cisco IOS image resilience?
A. secure boot-
B. secure boot-running-config
C. secure boot-start
D. secure boot-image
Explanation/Reference:
Explanation:
http://www.cisco.com/en/US/docs/ios/security/command/reference/sec_book.html secure boot-config
To take a snapshot of the router running configuration and securely archive it in persistent storage, use the secure boot-config command in global configuration mode. To remove the secure configuration archive and disable configuration resilience, use the no form of this command.
secure boot-config [restore filename]
no secure boot-config
Usage Guidelines
Without any parameters, this command takes a snapshot of the router running configuration and securely archives it in persistent storage. Like the image, the configuration archive is hidden and cannot be viewed or removed directly from the command-line interface (CLI) prompt . It is recommended that you run this command after the router has been fully configured to reach a steady state of operation and the running configuration is considered complete for a restoration, if required. A syslog message is printed on the console notifying the user of configuration resilience activation. The secure archive uses the time of creation as its filename. For example, .runcfg- 20020616-081702.ar was created July 16 2002 at 8:17:02.
The restore option reproduces a copy of the secure configuration archive as the supplied filename (disk0:running-config, slot1:runcfg, and so on). The restore operation will work only if configuration resilience is enabled. The number of restored copies that can be created is unlimited.
The no form of this command removes the secure configuration archive and disables configuration resilience.
Get Latest & Actual 640-554 Exam’s Question and Answers from Passleader.
http://www.passleader.com
An enable, disable, enable sequence has the effect of upgrading the configuration archive if any changes were made to the running configuration since the last time the feature was disabled. The configuration upgrade scenario is similar to an image upgrade. The feature detects a different version of Cisco IOS and notifies the user of a version mismatch. The same command can be run to upgrade the configuration archive to a newer version after new configuration commands corresponding to features in the new image have been issued. The correct sequence of steps to upgrade the configuration archive after an image upgrade is as follows:
Configure new commands
Issue the secure boot-config command secure boot-image To enable Cisco IOS image resilience, use the secure boot-image command in global configuration mode. To disable Cisco IOS image resilience and release the secured image so that it can be safely removed, use the no form of this command.
secure boot-image
no secure boot-image
Usage Guidelines
This command enables or disables the securing of the running Cisco IOS image. The following two possible scenarios exist with this command.
Then turned on for the first time, the running image (as displayed in the show version command output) is secured, and a syslog entry is generated. This command will function properly only when the system is configured to run an image from a disk with an Advanced Technology Attachment (ATA) interface. Images booted from a TFTP server cannot be secured. Because this command has the effect of “hiding” the running image, the image file will not be included in any directory listing of the disk. The no form of this command releases the image so that it can be safely removed.
If the router is configured to boot up with Cisco IOS resilience and an image with a different version of Cisco IOS is detected, a message similar to the following is displayed at bootup:
ios resilience :Archived image and configuration version 12.2 differs from running version 12.3. Run secure boot-config and image commands to upgrade archives to running version. To upgrade the image archive to the new running image, reenter this command from the console. A message will be displayed about the upgraded image. The old image is released and will be visible in the dir command output.
