Home » Cisco » 200-155 v.2 » Which command is required to enter the configuration prompt for VSAN as shown in figure?
Refer to the exhibit below, the figure shows CLI interface for VSAN configuration of Cisco MDS 9000 switch.
Which command is required to enter the configuration prompt for VSAN as shown in figure?
A. config t
B. vsan name
C. vsan
D. vsan database
Correct Answer: AD
Explanation/Reference:
Configuration terminal is not sufficient to enter vsan-db configuration prompt.
The vsan name command and ID can be created on vsan-db prompt which requires a vsan database command.
The vsan database command is used with vsan-db prompt to create a Vsan name and ID.
“Which command is required” is not plural. – D would be the answer
“Which commands are required” – A & D would be the answer.
switch(config)# vsan database
switch(config-vsan-db)#
Configures the database for a VSAN.
The command “vsan database” brings you to the “config-vsan-db” prompt which is required for further application specific VSAN parameters.