Refer to the exhibit.
The NOC team uses a source address of 77.232.115.149 and requires access only during the hours of 6:00PM through 6:00AM. The configuration is implemented as shown, but the NOC is unable to access the network until midnight.
Which configuration is required to fix the problem?
A. time-range Switch_Access
periodic daily 18:01 to 5:59
B. time-range NOC_Access
periodic daily 0:00 to 6:00
periodic daily 18:00 to 23:59
C. time-range NOC_Access
periodic daily 18:01 to 5:59
D. time-range Switch_Access
periodic daily 0:00 to 6:00
periodic daily 18:00 to 23:59
I make a LAB and both configurations work. I think the key here is from 18:00 not “18:01” through 06:00 not “05:59”
B is the correct answer
B is correct. access-list is switch_access, inside it there is time-range noc_access, inside it the 2 necessary entries (since it can’t be configured with just 1 entry).
The Time Range is “NOC Access” – so only B or C is possible
and as DomRod wrote : “You can not configure the time range with ending time is lower than the beginning time.”
–> B is the correct answer
It should be “B”
Actually, the answer should be “B” as the time -range is named “NOC_Access”. The ACL is called “Switch_Access”. it is the time-range command that needs to be adjusted.
The answer is D. You can not configure the time range with ending time is lower than the beginning time.
Here is the message when you try to configure the ans C.
R5(config-time-range)#periodic daily 18:01 to 6:00
Ending time must be greater than starting time