If you are required to configure a router to use MGCP on a digital port, which measure will you take?
A. Add the application mgcpapp subcommand to the dial peer
B. Add the service mgcp subcommand to the dial peer
C. Add the parameter application mgcpapp to the dsO-group controller subcommand.
D. Add the service mgcp parameter to the dsO-group controller subcommand
This IS the doc that confirms D is correct …..it says right there instead of using mgcpapp use service MGCP
https://books.google.com/books?id=_hGLWTaBk0gC&pg=PA249&lpg=PA249&dq=Add+the+application+mgcpapp+subcommand+to+the+dial+peer&source=bl&ots=EhQcrY4H7J&sig=ACfU3U36x2axELkQAe5ma7tNNlifjWgolQ&hl=en&sa=X&ved=2ahUKEwiUtbbQ7JLnAhXLJjQIHWCcCjsQ6AEwAnoECAsQAQ#v=onepage&q=Add%20the%20application%20mgcpapp%20subcommand%20to%20the%20dial%20peer&f=false
I concur, the correct answer is D. It’s for a digital port
But isn’t Answer A for analog ports? the question mentions digital port
The question is asking how to have the PRI backhauled to Call Manager using the MGCP protocol.
controller T1 1/0
framing esf
clock source internal
linecode b8zs
cablelength short 133
pri-group timeslots 1-24 service mgcp
https://www.cisco.com/c/en/us/support/docs/voice/media-gateway-control-protocol-mgcp/23966-mgcp-pri-cm.html#task1a
D is the correct answer
I greed with K0K0. The answered should A.
Enable MGCP for the port by entering the following commands:
Gateway(config)# dial-peer voice 1 pots
Gateway(config-dial-peer)# application mgcpapp port
Have not found any doc that confirms answer D is correct. Docs I’ve found indicate correct answer would be A.
See Example 5.3 Sample Configruation
https://docstore.mik.ua/univercd/cc/td/doc/product/lan/cat4224/sw_confg/voice.htm#1027975