Home » Cisco » 350-080 » Which of these commands will allow you to set end-host mode for SAN connectivity?
Which of these commands will allow you to set end-host mode for SAN connectivity?
A. UCS-A # scope fc-uplink
UCS-A /fc-uplink # set mode end-host
UCS-A /fc-uplink* # commit-buffer
B. UCS-A# scope eth-uplink
UCS-A /eth-uplink # set mode end-host
WarninG. When committed, this change will cause the switch to reboot
UCS-A /eth-uplink* # commit-buffer
C. UCS-A# scope fabric-interconnect a
UCS-A /fabric-interconnect # set mode end-host
UCS-A /fabric-interconnect* # commit-buffer
D. UCS-A# scope system
UCS-A /system* # set mode end-host
UCS-A /system* # commit-buffer
Correct Answer: A
Explanation/Reference:
Explanation:
When you change the Fibre Channel switching mode, Cisco UCS Manager logs you out and restarts the fabric interconnect. For a cluster configuration, Cisco UCS Manager restarts both fabric interconnects sequentially. The second fabric interconnect can take several minutes to complete the change in Fibre Channel switching mode and become system ready.
Reference: http://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/sw/cli/config/guide/2-2/b_UCSM_CLI_Configuration_Guide_2_2/b_UCSM_CLI_Configuration_Guide_2_1_chapter_0101.pdf (page 16)