A wireless engineer is calibrating a floor using Cisco Prime Infrastructure. Which setting in the WLC must be disabled before the floor calibration is started?
A. CleanAir
B. Dynamic Channel Assignment
C. Coverage Hole Detection
D. Tx Power Control
Seems D is the answer. From page 5-61 of https://www.cisco.com/c/en/us/td/docs/solutions/Enterprise/Mobility/WiFiLBS-DG.pdf
Temporarily disable Dynamic Transmit Power Control (DTPC) prior to conducting calibration data
collection. DTPC must be disabled separately for each band using either the controller GUI, the
controller CLI or WCS for each controller whose registered access points are expected to participate
in calibration data collection. After calibration data collection has been performed, DTPC should
be re-enabled for normal production operation
B is correct
I stand corrected, yes, D is the correct answer.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/wcs/4-0/configuration/guide/wcscfg40/wcsmaps.html#wp1084831
I think D
“Dynamic Power Assigment” must be disable.