Which two commands verify the DHCP snooping configuration on a device?

3 thoughts on “Which two commands verify the DHCP snooping configuration on a device?”

1. https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/ipaddr/command/ipaddr-xe-3se-5700-cr-book/ipaddr-xe-3se-5700-cr-book_chapter_010.html#wp7817396710

   Router# show ip dhcp pool 1
   Pool 1:
   Utilization mark (high/low) : 85 / 15
   Subnet size (first/next) : 24 / 24 (autogrow)
   VRF name : abc
   Total addresses : 28
   Leased addresses : 11
   Pending event : none
   2 subnets are currently in the pool :
   Current index IP address range Leased addresses
   10.1.1.12 10.1.1.1 – 10.1.1.14 11
   10.1.1.17 10.1.1.17 – 10.1.1.30 0
   Interface Ethernet0/0 address assignment
   10.1.1.1 255.255.255.248
   10.1.1.17 255.255.255.248 secondary

   Router# show ip dhcp snooping

   Switch DHCP snooping is enabled
   DHCP snooping is configured on following VLANs:
   5 10
   Insertion of option 82 is enabled
   Interface Trusted Rate limit (pps)
   ——————– ——- —————-
   FastEthernet6/11 no 10
   FastEthernet6/36 yes 50

   Reply

2. https://www.cisco.com/c/m/en_us/techdoc/dc/reference/cli/n5k/commands/show-ip-dhcp-snooping-binding.html

   switch# show ip dhcp snooping binding
   MacAddress IpAddress LeaseSec Type VLAN Interface
   —————– ————— ——– ———- —- ————-
   0f:00:60:b3:23:33 10.3.2.2 infinite static 13 Ethernet2/46
   0f:00:60:b3:23:35 10.2.2.2 infinite static 100 Ethernet2/10
   switch#

   Reply

3. https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst6500/ios/12-2SX/configuration/guide/book/snoodhcp.html

   To enable DHCP snooping globally, perform this task:

   Step 1
   Router(config)# ip dhcp snooping
   Enables DHCP snooping globally.

   Step 2
   Router(config)# do show ip dhcp snooping | include Switch
   Verifies the configuration.

   Reply