Home » Cisco » 100-101 » Which two commands will display the current IP address and basic Layer 1 and 2 status of an interface?
Which two commands will display the current IP address and basic Layer 1 and 2 status of an interface? (Choose two.)
A. router#show version
B. router#show ip interface
C. router#show protocols
D. router#show controllers
E. router#show running-config
Correct Answer: BC
Explanation/Reference:
Explanation:
The outputs of “show protocols” and “show ip interface” are shown below:
Global values:
Internet Protocol routing is enabled
Serial0/0 is up, line protocol is down
Internet address is 10.1.1.1/30
Serial0/1 is up, line protocol is down
Internet address is 209.65.200.225/30
Serial0/2 is up, line protocol is down
Serial0/3 is up, line protocol is down
NVI0 is up, line protocol is up
Interface is unnumbered. Using address of NVI0 (0.0.0.0)
Loopback0 is up, line protocol is up
Internet address is 10.1.10.1/32
Loopback1 is up, line protocol is up
Internet address is 10.1.2.1/27
Loopback6 is up, line protocol is up
Serial0/0 is up, line protocol is down
Internet address is 10.1.1.1/30
Broadcast address is 255.255.255.255
Address determined by non-volatile memory
MTU is 1500 bytes
Helper address is not set
Directed broadcast forwarding is disabled
Multicast reserved groups joined: 224.0.0.5
Outgoing access list is not set
Inbound access list is not set
Proxy ARP is enabled
Local Proxy ARP is disabled
Security level is default
Split horizon is disabled
ICMP redirects are always sent
ICMP unreachables are always sent
ICMP mask replies are never sent
IP fast switching is enabled
IP fast switching on the same interface is enabled
IP Flow switching is disabled
IP CEF switching is disabled
IP Feature Fast switching turbo vector
IP multicast fast switching is enabled
IP multicast distributed fast switching is disabled
IP route-cache flags are Fast
Router Discovery is disabled
IP output packet accounting is disabled
IP access violation accounting is disabled
TCP/IP header compression is disabled
RTP/IP header compression is disabled
Policy routing is disabled
Network address translation is enabled, interface in domain inside
BGP Policy Mapping is disabled
WCCP Redirect outbound is disabled
WCCP Redirect inbound is disabled
WCCP Redirect exclude is disabled
|
FULL Printable PDF and Software. VALID exam to help you pass.
|
 |
