An engineer is configuring a new mobility anchor for a WLAN on the CLI with the config wlan mobility anchor add 3 10.10.10.10 command, but the command is failing. Which two conditions must be met to be able to enter this command? (Choose two.)
A. The anchor controller IP address must be within the management interface subnet.
B. The anchor controller must be in the same mobility group.
C. The WLAN ID must be enabled.
D. The mobility group keepalive must be configured.
E. The indicated WLAN ID must be present on the controller.
B, E
•You must configure the WLANs on both the foreign controller and the anchor controller with mobility anchors
•You must add controllers to the mobility group member list before you can designate them as mobility anchors for a WLAN
https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-3/config-guide/b_cg83/b_cg83_chapter_010010.pdf
I think, AE sound correct.
BE sound correct
A doesn’t make any sense. It’s BE.