Which two steps are required as part of this process?

An engineer is deploying a Cisco TelePresence Touch 8 controller for a Cisco TelePresence SX20. Which two steps are required as part of this process? (Choose two.)
A. Connect the cable from the Touch 8 controller to the Cisco TelePresence SX20.
B. Connect the Touch 8 controller to the power adapter and connect the adapter to the network.
C. Connect the Touch 8 controller to the secondary network adapter on the Cisco TelePresence SX20.
D. Reboot the Cisco TelePresence SX20.
E. Hold the mute button down for 20 seconds while you power on the Touch 8 controller.

cisco-exams

7 thoughts on “Which two steps are required as part of this process?

  1. B,D is the correct answer
    The Touch 8 controller shall be connected to the network on the same subnet of SX20 device
    and the SX20 or any VC device shall be rebooted after connecting the Touch controller as per the touch controller installation guide.
    I think no other choices are applicable

  2. I am with Bob on this one. A & E. No second network port on the SX20 and nothing about holding down the mute button on the Touch 8 install guide.
    https://www.cisco.com/c/dam/en/us/td/docs/telepresence/endpoint/touch/installation_guide/touch_for_c-series_installation_sheet_for_web.pdf

    The questions here are good so long as you use them to look up the answers, but I have noticed that some of the provided answers are dead wrong. Suspiciously so since some of them are pretty basic. I suspect some of these incorrect answers were planted and unwittingly redistributed. Likely by trolls, but if I were paranoid it occurs to me that if certain answers were always answered incorrectly the same way that would be an easy enough thing for Cisco to track.

  3. The instructions do say the codec has to be rebooted so i think ‘D’ is one of the correct answers. Omar is correct that the SX20 does not have a secondary network adapter so I also think ‘B’ is correct. ‘A’ is not correct because you don’t connect the Touch 8 directly to the SX20. ‘E’ is also not correct because the manual says nothing about holding down the mute button for 20 seconds.

    https://www.cisco.com/c/dam/en/us/td/docs/telepresence/endpoint/touch/installation_guide/touch_for_c-series_installation_sheet_for_web.pdf

Leave a Reply

Your email address will not be published. Required fields are marked *


The reCAPTCHA verification period has expired. Please reload the page.