You are using an IPV6 environment and find that you need additional access control and want to set up some directional VPN rules. How can you restrict access based on destination? A. This can only be done in Traditional Mode…
What considerations are required when configuring IPV6 with Wire mode? A. IPv6 in Wire mode is only supported in R77. B. IPV6 must be configured on both end points. C. IPV6 is not supported in Wire mode. D. You must…
You are configuring OSPF on your Secure Platform firewall. You are in expert mode and run the commands: interface vt-Gateway_C IP ospf 1 area 0.0.0.0 exit When you run show running-config you do not see your OSPF configuration listed Why?…
Where can you configure OSPF on a GAiA firewall? A. cpconfig B. WebUI C. SmartDashboard D. sysconfig
Why would you choose to combine dynamic routing protocols and VPNs? A. All options listed. B. In the case of one tunnel failure, other tunnels may be used to route the traffic. C. Dynamic-routing information can propagate over the VPN,…
In Wire mode. if a packet reaches the gateway from a trusted source and is destined to a trusted destination, will the firewall do stateful inspection? A. No, but IPS inspection will still be enforced. B. Yes, the Firewall always…
Which routing protocols are not supported with GAIA OS running VTIs? A. RIPv1; RIPv2 B. BGP C. Static routes D. OSPF
You want to enable OSPF on Secure Platform, but you notice that the required gated daemon is not running. How can you enable this? A. Enter cpconfig, type Y to enable OSPF, type Y to restart Check Point services. B.…
Which Dynamic Routing Protocols are supported in GAiA in a Route-based VPN configuration? A. OSPF,BGP B. OSPF C. OSPF,BGP,RIPv2 D. OSPF,BGP,RIPv1,RIPv2
Jane wants to create a VPN using OSPF. Which VPN configuration would you recommend she use? A. Site-to-site VPN B. Domain-based VPN C. Route-based VPN D. Remote-access VPN