You are configuring OSPF on your Secure Platform firewall. You are in expert mode and run the commands:
interface vt-Gateway_C
IP ospf 1 area 0.0.0.0
exit
When you run show running-config you do not see your OSPF configuration listed Why?
A. You did not run command save running config before you exited.
B. You should not have moved to expert mode to make these configurations.
C. You did not run command save configuration before you exited.
D. You did not run command enable before you exited.
D – Note this is SPLAT not GAIA
By default, OSPF runs on configured interfaces. Therefore, if enable is not specified, it is the same as if the
user had specified the following:
(config)# interface fxp1
(config-if)# ip ospf 1 area 1.2.3.4
(config-if-ip-ospf)# enable <<<
(config-if-ip-ospf)# exit
(config-if)#
http://dl3.checkpoint.com/paid/11/CP_R75.40VS_SecurePlatform_AdvancedRoutingSuite_CLI_ReferenceGuide.pdf?HashKey=1552123051_3e40e40c786e248b5219169303a58072&xtn=.pdf