At any given time, each server can be associated with how many service profiles? A. 1 B. 5 C. 2 D. unlimited

Which statement is true regarding LACP configuration? A. LACP configuration is global and can be only configured by admin. B. With LACP, you can bundle up to 16 interfaces in a channel group. C. After removing LACP configuration, you need…

A customer is configuring an upstream disjoint Layer 2 network in a Cisco UCS domain So far they have configured the following: Fabric Interconnects are in switching mode. There is symmetrical configuration for high availability. There are no overlapping VLANs.…

You have a Cisco APIC that has a VIC 1225 adapter installed. Fabric discovery fails. You verify that the cabling is correct, but the LLDP fails. Which option is a possible cause of the failed fabric discovery? A. incorrect VIC…

Which two commands will help an administrator identify any issues with an In-Service Software Upgrade? (Choose two.) A. show incompatibility system B. show cts interface C. show install impact all D. show install issu-failure E. show license file

A customer is trying to boot an operating system that is installed on the eUSB on a Cisco UCS B-Series blade server, however, the boot fails. What is the cause of this failure? A. eUSB support is available only on…

Which command would you use to check the status of your configuration synchronization peer? A. N5K2# show peer status B. N5K2# show config-sync peer C. N5K2# show switch-profile peer D. N5K2# show synch peer

Which two conditions can prevent FCoE from functioning properly across a link? (Choose two.) A. LLDP is disabled. B. PFC was negotiated across the link. C. The VFC interface is down. D. DCBX is enabled on the device. E. The…

Which two protocols are important for DCBX to enable the "no drop" classes that are needed for lossless transmission? (Choose two.) A. PFC B. ETS C. FIP D. LLDP E. LACP

View the Exhibit. Refer to the exhibit. You configure a Cisco Nexus 5000 in NPV mode to enable multiple servers to log in over a single link to the NPIV switch. Which option describes why the interface is stuck on…