After upgrading a client’s fabric interconnect to the latest version, an engineer discovers that the appliance has lost its entire configuration. Which two locations should an engineer check to confirm that the appliance had backed up the configuration prior to…
Refer to an exhibit. An engineer is troubleshooting an upgrade failure on a switch. Which action resolves the issue? A. Save the system image in NVRAM. B. Use the same system image as the kickstart image. C. Load a new…
An IOM fails during a firmware upgrade and is unresponsive. Which action recovers the module? A. Restore UCSM configuration from backup. B. Roll back to the previous firmware. C. Use AutoInstall to reinstall the firmware. D. From the peer IOM,…
Refer to the exhibit. Cisco UCS Manager is being upgraded using the Auto Install feature, but the FSM fails. Which action resolves the issue? A. Acknowledge the primary fabric interconnect. B. Remove the service pack from the subordinate fabric interconnect.…
DRAG DROP A firmware upgrade on a fabric interconnect fails. A bootflash contains a valid image. Drag and drop the recovery steps from the left onto the correct order on the right. Select and Place:
A server administrator attempts to change the Cisco IMC KVM certificate to one signed by a private CA, but the certificate is not being accepted. What can cause this process to fail? A. using a certificate with a password-protected private…
Your client reports that many flaps and server cluster disconnects occur in their data center. While troubleshooting the issue, you discover a network attack hitting their Cisco Nexus 7000 Series Switches and determine that the source IP addresses are spoofed.…
A request to activate the port security database is rejected. Which action do you perform to investigate the cause of the issue? A. Enable the auto-learning feature. B. Use the force option to identify rejected devices. C. Find conflicting entries…
An engineer is troubleshooting a custom AV pair that was created by a client on an external authentication server to map a read-only role for a specific security domain. Which AV pair solves the problem? A. shell:domains=Security_Domain_1//Read_Role_1|Read_Role_2 B. shell:domains=Security_Domain_1/Write_Role_1|Read_Role_2 C.…
Refer to the exhibit. After the configuration is performed, guestshell continues to use 2%CPU. Which action resolves the issue? A. Resync the database B. Recreate the guestshell C. Reboot the guestshell D. Reboot the switch