Refer to the exhibit. An engineer troubleshoots why user 1, user 2, and user 3 from the group STORAGE-ADMINISTRATOR in Microsoft Active Directory cannot log in to the Cisco MDS SSH CLI. Which action resolves the issue? A. Configure the…
An engineer is implementing a storage VDC, but it fails. Which two prerequisites must be in place before a storage VDC is implemented? (Choose two.) A. M Series module B. ESSENTIALS license C. STORAGE-ENT license D. FCoE license E. F…
A user reports that they cannot reach from a UCS server to an FC Storage array. Which command is used to test communication between an FCF and a target? A. fcroute B. traceroute C. fcping D. ping
An engineer must place a Cisco UCS B-Series Server in a single server pool in Cisco UCS Manager. The engineer creates a qualification policy, but the server is still seen in multiple pools. Which two actions resolve the issue? (Choose…
Refer to the exhibits. An engineer troubleshoots switch N5K1, which fails to receive traffic from the file server. Which set of actions resolves this problem? A. Bind native VLAN 10 with Ethernet1/10 and allow VSAN 101 in trunk configuration. B.…
A system administrator adds two vNICs to an existing service profile that is used to run a vSphere environment to support disjoint Layer 2 network connectivity. However, after the server is rebooted, the host is not accessible on the network.…
Refer to the exhibit. A network engineer traces the packet flow from the Veth991 of a blade server toward the core switch. The switch reports performance issues. What is the role of the interface Eth1/7? A. IOM network interface B.…
A customer reports that the Chassis Management Controller fails to receive chassis information from Cisco UCS Manager. Which set of steps resolves the issue? A. 1. Verify that the IOM firmware and Cisco UCS Manager are at different software levels.…
An engineer must upgrade all components in a Cisco UCS domain to the same package version, but the upgrade process fails to complete. Which set of Auto Install actions resolves the problem? A. Install Server Firmware, then Install Infrastructure Firmware.…
During a boot process of a Cisco UCS C-Series Rack Server, an engineer receives a “No Signal” message from the vKVM and physical video connection. Which set of steps resolves the issue? A. 1. Disconnect the power cord. 2. Confirm…